Metal Open Toe Free Motion Quilting Embroidery Presser Foot for Brother Singer JANOME Domestic Sewing Machines

Works like a charm

Easy to use and fit my machine like a glove, sturdy and flexible with the free motion. Great value for the cost.

Been using it a bit longer feels flimsy but has held up well enough. Can't complain will post if it breaks or comes apart but so far so good can't complain fabric doesn't catch on the foot . Wire jiggles a bit.

Works well on my machine good purchase

Great for your sewing needs

This worked ok with my machine but it was hard to use and I felt that I don’t have the hand eye coordination for this project.

I purchased this free motion sewing foot to use with my Brother SE625 and leather needles to be able to sew patches on my leather vest. After watching YouTube videos and seeing how it was much easier to do with the free motion technique, I chose this foot. It was simple to install and simple to use. I practiced on a sample piece of fabric, and then I was off to the races. I had zero issues with the foot, and I had my patches all sewn on my vest in no time. Excellent value for the money.

Pin falls out when trying to free motion on my Janome. Such a headache and not worth the few dollars saved for an off brand piece.

I mean it was really easy to put on and it works, didn’t jam as I thought it was going to. Works like it’s supposed to. Singer M1500.

This product works if it seems like it is too short for your machine use it and you will see that it is not. This is better than the singer brand plastic one that they have.

Quilting is better because you can see what is happening while sewing!

This is a Low Shank Foot. My JUKI DDL 8700 uses High Shank. But was able to adjust it. Good Quality & i enjoy using it. I been looking for a open toe foot for a long time, because i needed to clearly see were the needle goes. At the moment, because of the temporary adjustment, i just sew in a slow pace. But i can sew faster later by adjust my presser foot bar down to make it stable if i'm doing more job that it demand the use of it after.

I got about halfway through my first small project and the pin at the top broke. It was very frustrating to say the least. The reason it broke was because the little pin at the top is not welded together with the rest if the foot and it is just a small metal pin/rod that gets pushed in and flattened a little to stay in place. I thought it was an easy fix, I would just use pliers to flatten it more and it would be as good as welded, but when I did the metal just kind of crushed like tin foil.So, because this wasn’t much cheaper than the actual singer brand option, I don’t think it’s worth the few bucks you might save. I’m writing this in detail because I hope to save someone out there who has it work for a little bit then has it bust mid project.This did not get through a very small project, maybe 1/8th a bobbin.