STINGERSPD5623 PRO Series Maxi Fused Power Distribution Block with (2) 1/0-Gauge Inputs and (4) 4/8-Gauge Outputs

Like other reviewers, circuits quit working and the connection from the fuse to the output block part melted into on two different circuits.

After One year of use I wake up to see my charge controller was shut down. After testing I find an output terminal on this fuse block with no voltage. Remove the fuse, test it, still good. Swap fuse and wire to another fuse connection and the charge controller works fine. It was a 60A fuse with a 40A load and the terminal went open. I may be able to take it apart and tighten the connection, but I think they should be better from the factory . I liked the product other than that.Update: A second fuse holder failed. This time the metal holding pressure on the fuse tab heated up, melted the plastic, and went open. 40A steady load 6 hours a day. I replaced it with a mini ANL holder. I think the tightened bolts is better that sprung tabs. Maybe these holders are just good for thumping bass, not a steady load. Two stars for failed safe.

Bought it when on sale for 25.00. Still pricey for a connection, but costs balance out because maxi fuses are cheap, but again how often will you replace fuses. Also love that you don't have to remove cover to replace fuses. Definitely larger and beefier than I thought it would be. Feels high quality and it is stinger branded. Would definitely purchase over again.!! No regrets

Yes it is a fuse holder I bought this to replace my older stinger fuse holder with only three fuses. This one has 4 fuses and feels very cheap . My old fuse holder was heavy built like a Tonka toy. This new one is much lighter and Built like it’s made out of diecast metal like a hot wheel toy car. All I can say is they don’t make them like they used to

Great fuse holder. Set screws fit nice and tight. Fuses went in very snug. I did pro car audio for almost two decades. I've seen a lot of these where the set screws were soft and got stripped out easily. I've also seen a lot of fuse holders where the blade slots were made with flimsy metal and couldn't grab the fuse blades sufficiently. This wasn't one of those products. Stinger is good stuff.

Used on a 1968 Charger as main fuse/power distribution. It holds fuses, looks good, and connects wires securely. Reasonably priced and does the job.

Just as described. Love it

Great for hooking multiple amps, caps etc safely

me satisfais pleinement

As described

not as advertised ...no fuses were included as described in advertisement ....

no me gusto que no especificaran que no incluye los fusibles