Mid-Size Truck Bed Unloader - LH3000M - Fits MID-Size Trucks

Amazing tool, works as advertised… hands down a must have for every to it ureselfer… I bought mine for my 72 year old father, he used to take the green waiste to a the dump and offload it by hand… backbreaking work for him.. he was hesitant at first, and there are a few tricks to using it… but after the first load he impressed.. and uses it all the time now…

Bought for Toyota Tacoma. Could not assemble with tailgate closed (as shown in instructions) due to no gap to run straps through where tailgate meets bed which made installation tricky. However, that was the only hiccup (reason for only 4 stars) . Tailgate closes fine with loadhandler installed. Mat has more than enough length and width. Haven't used yet to haul gravel/mulch. Will update

This thing is pricey (a bit too pricey actually for what it is), but the fact that I didn't have to get in the back of the bed with a shovel makes it worth it. It takes a bit of muscle to get it going at first, but it handles a full cubic yard of mulch pretty well. Hardware seems pretty quality too, thick metal and not flimsy stamped out crap, so hopefully it'll last. The tarp seems of decent quality too, and you could easily replace it with whatever if needed (it's literally just taped on and rolled up, nothing fancy). They actually sent the wrong product initially but swapped it out with no fuss.

There are a number of gadgets for unloading pickup truck beds. ‘very wide price range. Harbor Freight has one for less than fifty dollars. The cheap ones are primarily made of plastic; ‘pretty iffy. But okay maybe. I noticed that some units on YouTube were significantly better constructed than the cheapos. Specifically all-metal construction and notably BALL BEARINGS carrying the roller shaft. So, I bought that model and have thus far used it to unload split firewood. It meets all expectations. You get what you pay for.

This dose work I unloaded several 1/2 yard loads( the most weight it will carry) form my Toyota Tacoma. It unloads the majority of the load I still had to shovel/broom the sides of the bed where the drag sheet didn't go. But was still lot faster than unloading by hand.

This unloader is well made. I have unloaded 22 loads of 1500 pound 3/4 inch limestone and the unloader only shows the slightest signs of wear. ( see pic ) 1500 pound loads crank out without too much effort. Make sure and secure secondary straps to bumper once you open tailgate to keep tailgate flat while cranking. Tip Lay a tarp in bed then unloader mat on top. Once you crank out your product remainder stays in the tarp for easy pull out by hand. Not much if any need to shovel out bed. I was able to full offl oad limestone rock in abour 5 min. Should I ever wear this one out I will buy another one.

Well worth the money. Instructions could be a bit better but still easy to assemble. I’ve moved close to 10k pounds of gravel so far and no issues.

A little hard at the first to start unloading but after that it’s awesome! Saving my bad shoulder.