Frost King R734H Sponge Rubber Foam Tape 3/4" W X 7/16" H X 10' L, Black

flexible sponge rubber tape. Adhesive was okay. Easy to apply. Conforms easily.

Need this to block cold air leaks with main door and a bedroom window. Worked perfectly. Easy to apply and now my front door is not drafty and the bedroom window does not leak cold air at the base of window. Great price, shipped quick and recommend seller

Good product it sticks where you put it

I have used various type of weather strips annd they never stays in place and the adhesive is not strong enough to hold the weather strip in place. But this "Frost King Sponge Rubber weather strip is the best. I used this strip around my garage door and it held in place for the past three months and still going strong. All you need to do clean out the wood or whatever object you are going to install and then use the hair dryer or the heat gun to warm the object, in my case he wood before installing. This will make the adhesive to stick so good you will have a hard time peeling it off. Best qulaity for the money.

These were easy to install. Could be a bit longer but the thickness is adequate. These bend easily and these is no leakage if you lay them down correctly. Durability so far is good. Good price.

I don’t know this was used to sell a window where I had a small misting system line coming out. It didn’t stay on very well and wasn’t thick enough to sell the window for my purpose. However, perhaps for other uses it would be good.

Worked out well for what I needed this for. The adhesive was strong enough to stick to a carpet that was peeling. I had to cover the nail tips being exposed. Comes in a roll and easy to store.

I bought this for a different type of use rather than something I’d put around doors and windows to seal. I got this to line the edges of my PC case/tower on the inside. It’s an old one from a brand that doesn’t even make this specific case anymore, so what isn’t broken can still be used. However, it vibrates a lot from the fans and one hard drive I still have in use along the front panel. Cut a few small strips of this padding and put them along the front and side panels. Adhesive was like any other adhesive …. sticks and stays. Black blends in with the case and isn’t noticeable. Makes for troubleshooting so much easier when I need to listen for any ticking, coil whine, etc. rather than a constant humming vibration that starts whenever the case fans’ speeds go higher. I may use what’s left along the bottom of our back door as I can see it doing just fine for such as the foam isn’t too stiff and will fit.