Wathai 120mm 12V 0.45A 2Pin DC Brushless Cooling Fan 12 Volt 120x120x25mm | High CFM 5 inch Exhaust Fan Motor, 3000 RPM DIY 2-Wire Replacement

Worked as it should. It replaced a fan in a countertop icemaker. It is fairly quiet and runs smoothly

Perfect replacement for my GE Opal Ice Maker. As per instructions, this fan is slightly louder than the original, but not enough to make any difference considering where the ice maker is located. It is louder due to the 3K RPM rating which is fine with me because it operates at faster rotational speed (CFM) than the OEM version which makes the ice maker more efficient and produces ice a bit faster. The only anomaly is the power connector is not compatible with the controller board on the ice maker. I simply cut the old connector off the old fan and replaced the new connector on the new fan by soldering (blk to blk and red to red ) and using heat shrink tubing to protect the bare metal wire. You could probably use wire-nuts as well, but I prefer soldering.

Bought this to replace that fan in my 850w NZXT brand PSU that I've had for maybe 11 years now. My original fan had developed a rattle. I didn't want to replace the power supply as it was fine otherwise. The specs for my fan were 0.5a and 2500rpm. This fan was the closest I could find on Amazon to the original spec. It works perfectly. Even though it spins a bit faster it is pretty quiet. No louder than my original anyway. Solid buy.

I bought this fan to see if I could fix a portable dehumidifier. It turned out to be a circuit board failure, so I didn't need it after all. However, the kit is well equipped, that fan seems to be decently made, and the harness connector fit properly.

Works well. Used for pulling heat from camper's electrical cabinet. Good airflow for its size. Noise is not too bad.

This item was a perfect replacement. I used it to replace the cooling fan in bottom of upright drink cooler. My drinks were cold again. It hooked up just like the old one I took out. Very easy to replace.

Have this mounted in my truck to remove hot air so my amps can be cooler.

High quality product that was a good value. I got this to replace the fan for my opal ice maker. It worked great. I did have to change out the plug with the original, but instructions were included for that. The fan have nominal noise. The picture attached shows during installation.. The old fan is on the bottom right. Very satisfied with the outcome

Bon produit ça a bien fonctionné

Simplemente no funcionó, lo compré con exactamente las mismas características del ventilador anterior y éste no sirvió. Se devuelve.

Works great, moves a ton of air. Is louder then the fan it replaced but it also moves more air.