YONICO 14971q 3/4-Inch Diameter Bottom Cleaning Router Bit 1/4-Inch Shank

Does the job well and better quality than expected. Haven't used it enough to know how well it's going to last, but I'm happy with it so far.

good quality construction, cuts well. has stayed sharp through a few hundred plunge cuts so far. The painted sides make sure it does not get lost easily and add some brightness/cheer to the woodshop

Gave me workmanlike product in an experiment cutting 1/4" aluminum slowly with a handheld drill and a pilot hole. The cut produced a continuous thin sheet spiraling off of the plate.The Superglue experiment failed, but the hole is inconsequential and the Forstner bit is both fine and did not cause the failure- that was my initial design.There will be a success once the alternate, mechanical method to set the part that goes in the hole the bit hollowed almost perfectly by threading the pilot hole.

I bought this to relieve a cavity for some floating shelf brackets. It worked great and left a smooth floor on the mortise.

I tested this bit on arrival. It spins absolutely concentric and leaves a perfectly flat surface. I use these bits to refine scarf joints at fifteen degree angles in guitar necks. Bottom line, good bit, good price. I like it.

I've only cut two fairly short "T" track channels with it so far but it did a great job. Nice clean cuts through melamine and exactly the right size. I had previously used another "3/4" inch bit to cut some "T" track channels, but they were just too tight to fit the track into. It took a lot of work to make wide enough to fit the track. This bit is just perfect...track fits in nice and snug.

Works perfectly

good product