2PCs 8mm x 200mm (.315 x 7.874 inches) Case Hardened Chrome Plated Linear Motion Rod Shaft Guide - Metric h8 Tolerance

Rails are stiff and the width of the drill bit (5/16") used to create holes into which the rods were mounted. These were easier to work with than the usual flat rails, but it does cost a few dollars more.

Rods were of consistent size and straight, time will tell how they will wear but I'm optimistic.

Package was well packed, product was dimensional as described, quality of finish was great, shipping was on time. Nothing bad to say about the Reliabot products.

I have tested several rods using a dial indicator to check for straightness. I use the HF digital dial indicator on a magnetic stand. The key to getting consistent results is to have a follower that rides on top of the rod so that minor xy position error does not affect the dial indicator reading. I use a piece of glass as it provides a perfectly flat surface to the rod. Good stock rods are typically <0.05mm out of round. Unfortunately one of my boxes was damaged in shipping, but one of the rods was undamaged. It measured better than 0.01mm!. The second set of rods arrived in perfect condition with high denisty foam separating the rods and protecting them from the box at 5 different points. Customer service was excellent for the damaged box. I will update when I get a chance to test the second set of rods

Only one little thing ... at the ends of rod stock, the parting machine has slightly bulged the diameter, because it is a just-loose fit in accessories, it is easy to grind off a minute bit of that edge ... case hardened and coated with chrome is tough stuff, but on a grinding wheel no problem ...This is good stock, will make a lot of small machines easier to build, there are so many accessories available.

Great quality item! Exactly what I ordered. Great packaging. Fast delivery!

Llego a tiempo y es de buena xalidad

Needed to replace the 2 “Y” axis rods on my Prusa i3 mk2s. Out of the box these rods are smoother than the ones Prusa uses. Upon further inspection, I noticed when placed on a perfectly flat surface these rods are slightly bowed, although not by much. The stock rods that Prusa uses were 99.9% straight. Overall these new rods work fine.

I got two sets of these (Y (330mm) and Z (320mm) axis) for an LDO Bear2.1 upgrade for my 3d printer. Well packaged so they arrived in perfect condition. Accurate lengths and my standard bearing run nice and smooth with minimal noise.

I've built a custom 3d printer with it. Very happy, the quality is great.

Nice and straight. Sorted my printer out a treat

Falsch bestellt, gingen wieder zurück, haben aber nicht qualitativ besser ausgesehen als die originalen.

Salve,comprate e montate queste barre per una cnc. Che dire fanno il loro dovere sono moto ben rifinite i cuscinetti scorrono molto bene . Le consiglio !!!