Alumunum brake line lock hydraulic brake park lock pressure holder for Disc Drum 1/8"npt

Brass Fittings are junk. Manufactured poorly all around. Leaks . Leaked. Probably still leaking. Oh and It leaks just FYI. But hey if you want something to waste time and money on.......this will also get you frustrated and covered in wonderful brake fluid. You will tighten. Loosen. Install. Uninstall. Cuss. Retry . Then cuss some more all while wondering how something NEW can NOT WORK AT ALL. I feel like such an idiot to have that crazy expectation. And it leaks.

First unit failed upon installation, second unit purchased was assembled improperly. Both units repaired/resealed and function properly.

When installing this thing the brass fittings were stripped out. I had to replace them. After finally getting it installed, it leaked. I have lost so much money trying to get this thing to work and now I have to ship it back and wait for another one or a refund. I am almost done with Amazon and these cheap parts. I could have purchased a full new brake system for what I have spent trying to get this piece of junk to work.

Great product, works great

JUNK JUNK JUNK. This item is for automotive brake system. Ordered 2 for special application! I have over 30 years experience in the custom automotive industry! Never ever have I had a brake part leak fluid with no pressure applied. And flow like a river when pressurized! Fluid leaks out around the activation stem as if there’s no seal inside. This is for brakes this should no ever leak. This was a waste of little money and hours of my time running lines, doing proper flaring other parts. Oh did I mention my time!!!!!! JUNK. And a refund just doesn’t cover it. You people have no pride in product no respect for customers. And clearly no concerns of safety !!!!!! Mistake I’ll never make again

i like it because it is easy to mount you can put it under the dash or on the kick panel

I can't believe I wasted $23.00 on this piece of Cow Cookies! As soon as I went to bleed the brake system after installing this thing it leaked around the actuator! After I unscrewed the Plunger I noticed the O-ring had been installed incorrectly from the manufacturer and was "Pinched" and was allowing brake fluid to leak out. Naturally it was damaged beyond the point of usable and naturally due to its funky size and diameter I couldn't find a replacement for it. If you are thinking about ordering this hydraulic brake lock just spend the little bit of extra money and buy the JMAR brand or better yet just do what I wound up doing and go to Home Depot and buy a small brass ball valve. They work better and are MUCH easier and cheaper to find. E.N. Fort Worth Texas U.S.A.

The one I bought is taken down, this is the exact same one though. First the adapters are crap, they break when you tighten the flare nuts into them. 2nd, you need to use bubble flair, not double flair, this requires a steady hand and some basic tools, remember this thing needs to handle up to 2000psi hydraulic pressure. Here's to hoping the valve body itself will stand up too that, cause my craftsmanship is solid.