Rheem SP10552MH Resistored HWD with Screw-In 240-volt/4500-watt Element

Works well and easy to install. - Comes with gasket. At first I didn't see it, but it's wrapped around the part with the model number. - my original part number was AP10552MH , the part number on amazon ad is SP10552MH. this fits. As you can see by my photo the new element has almost the same number as my old one. Not sure why. it does fit and work. - this is one of the easiest repairs you can do, I'd recommend watching a video or two if you've never done it before.

Perfect fit, exact match. I was skeptical at first but it is identical to the old one I took of my 18 yr old Richmond. Came with the gasket like advertised. Is a Rheem manufacturer. It is a 4500/3380 (dual element). The one pictured is the old element (same as the new one). This is my first time changing an element and it ended up being a 4min job after gathering a Philips screwdriver, my new 1.5" element socket ($5), OHMs/voltage meter and a older towel. I had to do some research but it's a simple job if you know alittle about general house work. -Turn off power to water heater at breaker box. -Take covers off side (top/bottom). - double check that power is off by checking for voltage. -remove both wires to element. -check for OHMs, if there is no reading that is a bad element.(no reading=broken connection/bad element) -turn off the inlet water shut-off valve. -i didn't drain tank, I had the new element and towel ready and made the quick switch with about a quart of water spill onto the towel. It went very well! Just be very careful to not strip the threads and be ready to put the old one back in if there's complications. I may be missing a step but it's not as bad as I thought at first. I didn't measure the length but it fit in without issue, (eyeballed it on top of the tank, looked reasonable) I hope this helps someone who has never done this before, I was going to buy a new tank but I figure for the price it's worth a new element while I save a few bucks a month for a new tank later. Happy fixing!

As advertised

The order was quickly shipped and received only in a couple of days. The product is in higher cost performance. I will replace the heating elements with the ordered ones on the water heater in my home. It looks like that the part on the thread end used for being held by a wrench for installation is a little shorter. A special wrench tool (wrench socket) will be required for the heating element installation.

4500/240v works perfect. As described OEM

works like a charm, comes with rubber gasket

If you have a common 4500 watt electric water heater this is the perfect original replacement part. If you've never done this before don't worry, it's a very straight forward job.go for it. Elements are copper and come with new rubber seal. All that's needed is the $5.00 1 1/2" element tool and a Phillips screw driver. Have you seen the price of new water heaters!? If your tank is going haywire but not leaking don't throw money away on a new one. I replaced everything including the sacrificial anode for under $50.00 here on Amazon and we're back in the hot water again. I received nothing for my review I'm not associated with this product I recommend this product

The product fit perfectly, and functions perfectly. It was easy to remove/replace the old one and have a fully functioning hot water heater again.

Came quickly, installed fine and seem to work good.

Bueno producto

Buen producto…vuelvo a comprar!!! Muy buena refaccion

Demora la entrega pero vale la pena