Wall Stickers 3D (520, White)

Love these not a fan of stark white but bricks can be tweaked in many ways!Did my kitchen & fiends sunroom with different glazes!

Make sure you cut out the Bricks in a zig zag (puzzle like) instead of leaving the entire square uncut, with the straight edge because you'll be able to see a dividing line.It made my closet look so much better! I did a complete DIT closet makeover. People actually thought I laid bricks. I'll post before and after photos.

Love it!

This is a difficult review. First I have to say...I think they're on to something but need to refine the product.Second, it's SUPER difficult to get the edging to line up right to each square - they can NOT overlap (totally noticeable). Meaning, you have to slowly and meticulously cut each and EVERY side to match the space between the "bricks" inside the square itself. If you're off even a little bit, it's totally obvious. Each square's side is totally different (yes all 4 sides!!), the edging isn't even straight and definitely do NOT match the next piece. If you were only going to do one row (so you're only doing one square side by side instead of the entire wall) and have a chair rail or some type of break between the top of the squares and the rest of the wall, it will take you less time, but still... I assumed each square, sides and all, were universally the same, so I put the first square right up. Needless to say, when I tried to line up the next square, that's when I noticed it was not the same, so I had to remove the first square - to the garbage it went (they can not be pulled off and reused). Then I laid the squares out together on the floor, that's when I noticed how each one was different. They are still laying in a heap on the floor of my office because I have not had the time it's going to obviously take to do one row, of about 25 feet of wall. I may just end up painting the cheesy wood paneling and be done with it.The product itself? They're obviously not brick, but from a distance they do kinda look real. I think that in a small office, small bedroom, laundry room, it might just look okay, if done right. In my opinion, it's a bit too cheesy for a main room (living room, kitchen, dining room, sun room, etc). Due to the material, I would NOT recommend it in a bathroom with a shower/bath. I have not tried to paint them, but knowing a bit about painting, unless you used a spayer (NOT spray can) and put primer first... it just might be doable, but would definitely harden them and I recommend doing it after installation.I gave this product (3D brick wall stickers, white) 2 stars because, I think that if I had the time, or paid someone else to do it, they "might" look okay in my 8'x20' office.

OMG If I could cover my whole house in this I would, I love these....wish wish wish they came in colors...they just have white

I used about 22-25 sheets for this wall. I think it looks great. A little pricey for the amount given.

This is a hard product to review because I actually like it, but it isn’t easy to cut and install. It has very sticky adhesive so once it’s on the wall, it’s on there. We had to cut it with a razor knife, which did ok. I love the finish look but there are a few spaces where there’s a slight gap, because once the backing paper comes off, the sticker actually stretches if you’re not careful. Definitely can’t just throw it up and be done like I though...

These panels are fantastic! I used them as the 'bottom portion' under a chair rail and they quite natural. They are extremely easy to work with, the installation was completed using household scissors in under an hour. Great product, delivered on time.

Horrible calidad, la devolución la tengo que pagar yo y ninguna paqueteria se lo quiere llevar...NO LO COMPREN CALIDAD FATAL, EL VENDEDOR NO SE DIGNA A CONTESTARAdemas nunca recibi la devolucion de mi dinero